SAE J 1304:2011-10-25

For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per 'Cutting Edge—Cross Sections Loader Straight,' SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters.

Author	SAE
Editor	SAE
Document type	Standard
Format	File
ICS	53.100 : Earth-moving machinery
Number of pages	3
Replace	SAE J 1304:2006-02-05
Set	JPAKS10U-10
Year	2011
Document history	SAE J 1304:2006-02-05
Country	USA
Keyword	SAE 1304;SAE J1304;SAE J1304;SAE J 1304